Subject: cpumask: Use accessors code.: powerpc From: Rusty Russell Impact: use new API Use the accessors rather than frobbing bits directly. Most of this is in arch code I haven't even compiled, but is straightforward. Signed-off-by: Rusty Russell Signed-off-by: Mike Travis --- arch/powerpc/kernel/setup-common.c | 4 ++-- arch/powerpc/platforms/powermac/setup.c | 2 +- 2 files changed, 3 insertions(+), 3 deletions(-) --- linux-2.6.28.orig/arch/powerpc/kernel/setup-common.c +++ linux-2.6.28/arch/powerpc/kernel/setup-common.c @@ -413,7 +413,7 @@ void __init smp_setup_cpu_maps(void) j, cpu, intserv[j]); cpu_set(cpu, cpu_present_map); set_hard_smp_processor_id(cpu, intserv[j]); - cpu_set(cpu, cpu_possible_map); + set_cpu_possible(cpu, true); cpu++; } } @@ -459,7 +459,7 @@ void __init smp_setup_cpu_maps(void) maxcpus); for (cpu = 0; cpu < maxcpus; cpu++) - cpu_set(cpu, cpu_possible_map); + set_cpu_possible(cpu, true); out: of_node_put(dn); } --- linux-2.6.28.orig/arch/powerpc/platforms/powermac/setup.c +++ linux-2.6.28/arch/powerpc/platforms/powermac/setup.c @@ -366,7 +366,7 @@ static void __init pmac_setup_arch(void) int cpu; for (cpu = 1; cpu < 4 && cpu < nr_cpu_ids; ++cpu) - cpu_set(cpu, cpu_possible_map); + set_cpu_possible(cpu, true); smp_ops = &psurge_smp_ops; } #endif