cpumask: Use accessors code.: sh Use the accessors rather than frobbing bits directly. Most of this is in arch code I haven't even compiled, but is straightforward. From: Rusty Russell Signed-off-by: Rusty Russell Signed-off-by: Mike Travis --- arch/sh/kernel/cpu/sh4a/smp-shx3.c | 5 ++--- arch/sh/kernel/smp.c | 6 +++--- 2 files changed, 5 insertions(+), 6 deletions(-) --- linux-2.6.28.orig/arch/sh/kernel/cpu/sh4a/smp-shx3.c +++ linux-2.6.28/arch/sh/kernel/cpu/sh4a/smp-shx3.c @@ -19,8 +19,7 @@ void __init plat_smp_setup(void) unsigned int cpu = 0; int i, num; - cpus_clear(cpu_possible_map); - cpu_set(cpu, cpu_possible_map); + init_cpu_possible(cpumask_of(cpu)); __cpu_number_map[0] = 0; __cpu_logical_map[0] = 0; @@ -30,7 +29,7 @@ void __init plat_smp_setup(void) * for the total number of cores. */ for (i = 1, num = 0; i < NR_CPUS; i++) { - cpu_set(i, cpu_possible_map); + set_cpu_possible(i, true); __cpu_number_map[i] = ++num; __cpu_logical_map[num] = i; } --- linux-2.6.28.orig/arch/sh/kernel/smp.c +++ linux-2.6.28/arch/sh/kernel/smp.c @@ -52,7 +52,7 @@ void __init smp_prepare_cpus(unsigned in plat_prepare_cpus(max_cpus); #ifndef CONFIG_HOTPLUG_CPU - cpu_present_map = cpu_possible_map; + init_cpu_present(&cpu_possible_map); #endif } @@ -63,8 +63,8 @@ void __devinit smp_prepare_boot_cpu(void __cpu_number_map[0] = cpu; __cpu_logical_map[0] = cpu; - cpu_set(cpu, cpu_online_map); - cpu_set(cpu, cpu_possible_map); + set_cpu_online(cpu, true); + set_cpu_possible(cpu, true); } asmlinkage void __cpuinit start_secondary(void)