<div>Hi All,</div>
<div> </div>
<div>For my project work(Packet filter) we are planning to buy a used WindRiver EST SBC8260 board.</div>
<div>I am new to this. So i request everyone to suggest me what i should look for while buying the board.My development environment will be LINUX may be vxworks in future.</div>
<div> </div>
<div>1) My dealer is providing only the Board. ( <font size="2">4MB-SIMM flash,<font size="2">16MB-SDRAM DIMM, 8k<font size="2">b- 8 bit EEPROM, <font size="2">2MB- 8 bit Flash, <font size="2">4MB SDRAM (Local Bus), <font size="2">
RS-232, <font size="2">10/100 Base-TX Ethernet)</font></font></font></font></font></font></font></div>
<div> Is it enough -or whether i need any extra addon cards</div>
<div> </div>
<div>2) Do i need to buy JTAG debugger or any</div>
<div> Is it possible to debug the code without JTAG/BDM</div>
<div> </div>
<div>3) what are the cables i need</div>
<div> </div>
<div>4) Can i directly download the bootcode from my PC to the Board through ethernet/serial port</div>
<div> </div>
<div>5) Can anyone provide me the user manual for the above board. any weblinks are also good</div>
<div> </div>
<div>6) any other points</div>
<div> </div>
<div>Thanks</div>
<div>mjose</div>
<div> </div>