U-Boot 1.1.3 (FSL Development) (Jun 13 2006 - 14:01:25) MPC83XX
 
Clock configuration:
  Coherent System Bus:  132 MHz
  Core:                 264 MHz
  QE:                   198 MHz
  Local Bus Controller: 132 MHz
  Local Bus:             66 MHz
  DDR:                  264 MHz
  SEC:                  132 MHz
  I2C1:                 132 MHz
CPU: MPC8323E, Rev: 10 at 264 MHz
Board: Freescale MPC832XEPB
I2C:   ready
DRAM:
   DDR RAM: 128 MB
FLASH: 16 MB
In:    serial
Out:   serial
Err:   serial
Net:   FSL GETH0
Hit any key to stop autoboot:  0
=> printenv
ramboot=setenv bootargs root=/dev/ram rw console=$consoledev,$baudrate $othbootargs;tftp $ramdiskaddr $ramdiskfile;tftp $loadaddr $bootfile;bootm $loadaddr $ramdiskaddr
bootdelay=6
loads_echo=1
loadaddr=200000
netdev=eth0
ramdiskaddr=400000
ramdiskfile=ramfs.83xx
ethact=FSL GETH0
ethaddr=00:04:9f:00:00:00
ipaddr=10.0.6.65
netmask=255.255.0.0
serverip=10.0.0.107
gatewayip=10.0.0.1
rootpath=/opt/eldk/ppc_6xx
bootfile=uImage
baudrate=9600
consoledev=uart,io,0xfe004500
bootargs=root=/dev/nfs rw nfsroot=10.0.0.107:/opt/eldk/ppc_6xx ip=10.0.6.65:10.0.0.107:10.0.0.1:255.255.0.0:eth0:off console=uart,io,0xfe004500
nfsboot=setenv bootargs root=/dev/nfs rw nfsroot=$serverip:$rootpath ip=$ipaddr:$serverip:$gatewayip:$netmask:$netdev:off console=$consoledev $othbootargs;tftp $loadaddr $bootfile;bootm $loadaddr
bootcmd=run nfsboot
stdin=serial
stdout=serial
stderr=serial
 
Environment size: 871/8188 bytes
=>