[root@dxp filesystem]# kermit -c Connecting to /dev/ttyS0, speed 9600 Escape character: Ctrl-\ (ASCII 28, FS): enabled Type the escape character followed by C to get back, or followed by ? to see other options. ---------------------------------------------------- U-Boot 1.1.4 (Nov 11 2005 - 19:35:30) AMCC PowerPC 440EP Rev. B Board: Yosemite - AMCC PPC440EP Evaluation Board VCO: 1066 MHz CPU: 533 MHz PLB: 133 MHz OPB: 66 MHz EPB: 66 MHz PCI: 66 MHz I2C: ready DRAM: 256 MB FLASH: 64 MB PCI: Bus Dev VenId DevId Class Int In: serial Out: serial Err: serial Net: ppc_4xx_eth0, ppc_4xx_eth1 Type "run flash_nfs" to mount root filesystem over NFS Hit any key to stop autoboot: 0 => => tftp 400000 uImage ENET Speed is 100 Mbps - FULL duplex connection Using ppc_4xx_eth0 device TFTP from server 192.168.0.93; our IP address is 192.168.0.66 Filename 'uImage'. Load address: 0x400000 Loading: ################################################################# ################################################################# ################################################################# ########################################## done Bytes transferred = 1212624 (1280d0 hex) => tftp 4000000 ramdisk.img Using ppc_4xx_eth0 device TFTP from server 192.168.0.93; our IP address is 192.168.0.66 Filename 'ramdisk.img'. Load address: 0x4000000 Loading: ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ############################################# done Bytes transferred = 8547050 (826aea hex) => bootm 400000 4000000 ## Booting image at 00400000 ... Image Name: Linux-2.6.14 Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1212560 Bytes = 1.2 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Uncompressing Kernel Image ... OK ## Loading RAMDisk Image at 04000000 ... Image Name: Yosemite Ramdisk Image Type: PowerPC Linux RAMDisk Image (gzip compressed) Data Size: 8546986 Bytes = 8.2 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Loading Ramdisk to 0f713000, end 0ff39aaa ... OK Linux version 2.6.14 (root@dxp) (gcc version 4.0.0) #1 Sat Nov 12 23:29:30 CST 2005 AMCC PowerPC 440EP Yosemite Platform Built 1 zonelists Kernel command line: PID hash table entries: 2048 (order: 11, 32768 bytes) Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) Memory: 248576k available (1852k kernel code, 604k data, 136k init, 0k highmem) Mount-cache hash table entries: 512 checking if image is initramfs...it isn't (no cpio magic); looks like an initrd softlockup thread 0 started up. Freeing initrd memory: 8346k freed NET: Registered protocol family 16 PCI: Probing PCI hardware usbcore: registered new driver usbfs usbcore: registered new driver hub SCSI subsystem initialized io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered usbmon: debugfs is not available ppc-soc-ohci ppc-soc-ohci.0: USB Host Controller ppc-soc-ohci ppc-soc-ohci.0: new USB bus registered, assigned bus number 1 ppc-soc-ohci ppc-soc-ohci.0: irq 40, io mem 0xef601000 usb usb1: Product: USB Host Controller usb usb1: Manufacturer: Linux 2.6.14 ohci_hcd usb usb1: SerialNumber: PPC-SOC USB hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected Initializing USB Mass Storage driver... usbcore: registered new driver usb-storage USB Mass Storage support registered. pegasus: v0.6.12 (2005/01/13), Pegasus/Pegasus II USB Ethernet driver usbcore: registered new driver pegasus Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled serial8250: ttyS0 at MMIO 0x0 (irq = 0) is a 16550A serial8250: ttyS1 at MMIO 0x0 (irq = 1) is a 16550A RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize PPC 4xx OCP EMAC driver, version 3.53 mal0: initialized, 4 TX channels, 2 RX channels zmii0: bridge in RMII mode eth0: emac0, MAC 00:10:ec:00:87:40 eth0: found Generic MII PHY (0x01) eth1: emac1, MAC 00:10:ec:00:87:47 eth1: found Generic MII PHY (0x03) Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx AMCC440-flash: Found 1 x16 devices at 0x0 in 16-bit bank Amd/Fujitsu Extended Query Table at 0x0040 AMCC440-flash: CFI does not contain boot bank location. Assuming top. number of CFI chips: 1 cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness. Creating 5 MTD partitions on "AMCC440-flash": 0x00000000-0x00180000 : "kernel" 0x00180000-0x00400000 : "root" 0x00400000-0x03f40000 : "user" 0x03f40000-0x03f80000 : "env" 0x03f80000-0x04000000 : "u-boot" mice: PS/2 mouse device common for all mice NET: Registered protocol family 2 IP route cache hash table entries: 4096 (order: 2, 16384 bytes) TCP established hash table entries: 16384 (order: 4, 65536 bytes) TCP bind hash table entries: 16384 (order: 4, 65536 bytes) TCP: Hash tables configured (established 16384 bind 16384) TCP reno registered TCP bic registered NET: Registered protocol family 1 NET: Registered protocol family 17 RAMDISK: Compressed image found at block 0 RAMDISK: incomplete write (-28 != 32768) 4194304 VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 136k init attempt to access beyond end of device ram0: rw=0, want=32776, limit=8192 EXT2-fs error (device ram0): ext2_get_inode: unable to read inode block - inode=4001, block=16387 Warning: unable to open an initial console. attempt to access beyond end of device ram0: rw=0, want=49538, limit=8192 EXT2-fs error (device ram0): ext2_get_inode: unable to read inode block - inode=6003, block=24768 attempt to access beyond end of device ram0: rw=0, want=65544, limit=8192 EXT2-fs error (device ram0): ext2_get_inode: unable to read inode block - inode=8001, block=32771 attempt to access beyond end of device ram0: rw=0, want=16770, limit=8192 EXT2-fs error (device ram0): ext2_get_inode: unable to read inode block - inode=2001, block=8384 Kernel panic - not syncing: No init found. Try passing init= option to kernel. <0>Rebooting in 180 seconds..