<DIV>Host computer: AMD ( I think K8 amd cpu which is i686)</DIV>
<DIV>target: custom board (XC2VP4 fpga that contains ppc405, and build around the ppc405 are peripherals UARTLITE, SPI controller, SDRAM controller, PLB (processor locus bus). I have used serial SPI flash from ST(M25P32). NO ETHERNET</DIV>
<DIV> </DIV>
<DIV>GNU toolchain I build ==> binutils (2.10.1) gcc (2.95.3), glibc (2.2.1) includes 2.2.1 linuxthread.</DIV>
<DIV> </DIV>
<DIV>I have follow instructions from "Building Embedded Linux Systems" book to build the kernel image. After I follow up to chapter to 5, the follow instructions that I did are</DIV>
<DIV> </DIV>
<DIV> $make ARCH=ppc CROSS_COMPILE=powerpc-linux- clean dep</DIV>
<DIV> $make ARCH=ppc CROSS_COMPILE=powerpc-linux- zImage</DIV>
<DIV> $make ARCH=ppc CROSS_COMPILE=powerpc-linux- moudles</DIV>
<DIV> </DIV>
<DIV>during step "installing the kernel" on page 167, I look under /arch/ppc/boot/zImage, and could not find the zImage. <== don't know why, I had seen the other files like system.map, vmlinux .config.</DIV>
<DIV> </DIV>
<DIV>other questions I want to ask is seen I have use serial spi flash memory (ST M25P32) ==> how do I build the "Root file system" on this flash, how do I do with the MTD, and bootloader. I am new to this stuff, so I don't what to do. </DIV>
<DIV> </DIV>
<DIV>thanks.</DIV><p>__________________________________________________<br>Do You Yahoo!?<br>Tired of spam? Yahoo! Mail has the best spam protection around <br>http://mail.yahoo.com