MTD/JFFS2 on Intel 28F160F3

Sat Aug 10 01:01:27 EST 2002

>
> The basic problem is what the physical start address of flash mapping
> is? While on PPCBoot, I got flash information using command 'flinfo'.
> The start address is FFE00000. Is this address the one used to configure
> CFI flash device in physical memeory map? I tried using this address but
>  'physmap' couldn't find flash device.

It is not a must that the address mapping in PPCBoot is the same as in
the kernel.

What board are you using ?

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/